Easy how-to guides

1. 1

   Step 1: Soften the mouth tray

   Boil water in a pot or kettle and then let the heat reduce slightly so that the water is no longer bubbling. If a kettle was used continue to pour the water into a bowl. Whilst holding the tab on the front of the mouth tray, submerge it into the boiling water and stir for 3-6 seconds.

   Overheating may damage or over-shrink the tray.

2. 2

   Step 2: Bite to mould it

   You will notice the tray begin to wilt. Allow the tray to cool just enough to eliminate the possibility of burning your mouth and bite it firmly.

3. 3

   Step 3: Trim the handle

   Carefully cut off the mouth tray handle using a pair of scissors. Please repeat steps 1-3 with a new mouth tray for your bottom set of teeth.

4. 4

   Step 4: Add the gel

   Apply a small 'bead sized' amount of solution to the middle of each tooth's imprint you wish to whiten. Please note the amount of solution should be enough to cover the whole front surface of each tooth without it overflowing onto your gums.

5. 5

   Step 5: Put the trays in

   Position the mouth trays in your mouth and press the sides with your fingers to spread the gel evenly over the teeth.

6. 6

   Step 6: Switch on the light and relax

   Once the gel filled mouth trays are in place, open the battery compartment and remove the plastic electric-current stopper placed below both batteries. Once done, replace the batteries, turn on and place the device over the top of the trays for the entire duration. Then sit back and relax for 30-60 minutes whilst BrighterWhite works away!

   The battery stopper only needs removing the first time.

7. 7

   Step 7: Rinse and repeat

   Once complete, remove and wipe all components and rinse your mouth. Repeat applications for 7-14 days once or twice a day depending on your current tooth shade and goal tooth shade.

Timing, results and sensitivity

• How long and how often

  30-60 minutes per session, once or twice a day, for 7-14 days depending on your current and goal tooth shade.

• When you'll see results

  Users typically reach their desired shade within 2-7 days of 30-60 minute daily applications.

• If your teeth feel sensitive

  When used as recommended, sensitivity is not common. If you feel light sensitivity for a short period after treatment, use the desensitisation gel in the same way and for the same time as the whitening gel, without the LED Accelerator Light.

• Keeping your shade

  Results depend on the foods and drinks you regularly have. Generally one application every 2-4 weeks keeps your new shade once you reach it.

1. 1

   Step 1: Prep the pen

   Firstly ensure your teeth are clean, then shake the pen well for 5 seconds, remove cap and twist the bottom clockwise several times until the gel covers the brush tip.

2. 2

   Step 2: Paint it on

   Gently apply a thin layer of gel onto the front of each tooth you wish to whiten, avoiding gums or lips.

3. 3

   Step 3: Smile for 20 seconds

   Wait 20 seconds for the gel to dry on your teeth before allowing contact with lips and tongue (smile for 20 seconds). Once completed, leave gel on and wipe off several hours later.